UniPi Case Zero
The UniPi Case Zero for Raspberry Pi Zero
The UniPiCase is a secure, feature-rich case made to the best design and fabrication standards. This is our own case design, and it is manufactured here in Canada!
There are two main versions of the UniPi Case Zero, the Standard version for the Raspberry Pi Zero and a Tall version that is compatible with the Raspberry Pi Zero WH.
There are a number of different variations for each version of the case. This makes the UniPi Case Zero incredibly configurable, and can fit almost any project.
UniPi Case Zero Versions & Variations
Standard Version
- Your brand or logo can be embossed on the glossy top surface of the lid during injection molding
- Regular cases accommodate a Pi Zero/Zero W board, and optionally an official Raspberry Pi camera
- Regular face-plates are available in standard or power-only port configurations
Standard Case, All Ports Open
Standard Case, Power Port Open
Camera Case, All Ports Open
Camera Case, Power Port Open
Tall Version
- Your brand or logo can be embossed on the glossy top surface of the lid during injection molding
- Tall cases accommodate a Pi Zero / Zero W board, as well as an add-on board such as an audio or I/O board
- Tall face-plates are customized to your port requirements, and embossed text can be added to your face-plate
- Tall lids have a GPIO port for a GPIO I/O ribbon cable to connect the Pi to a cobbler/breadboard
Tall Case, Stock Faceplate
Tall Case, Sample Audio Ports
Tall Case, Sample Speaker Ports
Tall Case, Sample Audio Ports
FEATURES
- This Standard version accommodates a Pi Zero or Zero W board.
- The HDMI and microUSB ports are closed off, allowing access only to the Power port.
- A wide base provides stability for the case when heavy HDMI cables are attached.
- The entire case assembles without tools, but requires a small screwdriver or pen to remove it, securing the contents.
- The lid can be removed for inspection without disconnecting any cables from the Pi or powering it down.
- Ports for the Pi Zero/Zero W are labeled on the base to avoid confusion between the USB and PWR ports.
- A camera cable slot on the underside of the case allows external cameras to be connected.
- Low-profile silicon feet are included, to hold the case in place on hard surfaces.
- The case can be wall mounted using two pre-marked invisible mounting holes at each end.
DIMENSIONS
- ABS injection molded plastic
- 91 x 46.5 x 18 mm, 17.5 g [3.60 x 1.83 x 0.71 in, 0.62 oz]